Section Iii: Pre-Fab Insert Installation - New Buck Corporation 21NC Preparations, Installation, Operation, Maintenance, Safety

Fireplace insert & freestanding non-catalytic unit
Table of Contents

Advertisement

PRE-FAB INSERT INSTALLATION
The Model 21 has been tested with the following:
Heatilator
Security
Tempco
Preway
Marco
FMI
Woodside
Majestic
NOTE: The Model 21 may be installed in any of the pre-fabricated fireplaces listed above if
they are big enough to accept heater.
NOTE: A FULL CHIMNEY LINER IS REQUIRED IN A ZERO CLEARANCE OR PRE -
FABRICATED FIREPLACE.
NOTE: The ash lip, smoke baffle and smoke shelf may be removed if necessary to provide
room for these models. Any other alteration to unit will void ALL NEW BUCK
CORPORATION, responsibility and liability. The warning label below must be
attached to the pre- fabricated fireplace before unit is installed.
"notes"
Except for the
including Minimum Clearances for stove and floor protector in Section II.
NOTE: When installing trim panels DO NOT COVER ANY EXITING LOUVERS OR AIR
OPENING IN PRE-FABRICATED FIREPLACE .
SECTION III
above, please follow the instructions for Masonry Insert Installation
WARNING:
This fireplace must be
restored to its original condition for safe use,
if the fireplace insert is removed.
Page 13

Advertisement

Table of Contents
loading

This manual is also suitable for:

21Zc21

Table of Contents