Tap Mode; Break Mode - Monster Go-DJ Manual And Warranty

DIGITAL TURNTABLES SCREEN

Tap Mode

When the highlight bar in the Arc Selector is positioned over the Tap command
and the track is playing, you can activate the Tap function by pressing the
FUNCTION knob. With the Tap function, you can manually adjust the BPM and
the beat position by tapping the turntable. The newly analyzed value of BPM
is displayed in red until it is determined. When you press down the FUNCTION
knob again, the new BPM value is confirmed and registered. In the case that
you rotate the FUNCTION knob before pressing down, the measured value of
BPM is abandoned.

Break Mode

When the highlight bar in the Arc Selector is positioned over any of the Loop
commands while the track is playing, the Break mode is activated. In Break
mode, when you touch the turntable, the track slows down gradually before
stopping. The selected Loop range corresponds to the number of beats that
pass until the track is slowed down and stopped. When you release the hand
from the turntable, the track accelerates and goes back to the original speed.
If the slip mode is ON in the option screen, the turntable restarts to turn at the
original speed immediately after stopping, and the track starts to play when
the turntable is released.
39