Battery Charger Assembly - Projecta HDBC90 User Manual

BATTERY CHARGER ASSEMBLY

Your HDBC90 is shipped with the following parts which require assembly to the main
body of the battery charger unit:
• 1 x Battery Charger Handle
• 4 x 50mm Screws
• 1 x Bottom Stabiliser Stop
• 2 x 50mm Self Tapping Screws
• 2 x Trolley Wheels
• Wheel Axle
• 2 x Black Voltage Terminal Caps
• 2 x 35mm Washers
• 2 x Wheel Locking Rings.
1. Place the main body of the battery charger in an upright position, install the top handle
of the battery charger using the 4 x 50mm screws as per the below illustration. Use a
Phillips head screw driver to tighten all 4 screws.
2. Lay the main body of the battery charger down flat and fit the stabiliser stop to the
bottom of the battery charger using the 2 x 50mm self tapping screws provided. Use
a Phillips head screw driver to tighten screws.
3. Place the wheel axle provided through the bottom of the battery charger as per the
below illustration.
4. Place the 2 x 35mm washers on either
end of the axle.
5. Fit the 2 trolley wheels to either end of
the axle and secure with the 2 x wheel
locking ring's provided.
6. Screw the 2 x black voltage terminal
caps provided to both the 12V &
24V outlets on the top panel of the
battery charger.
HDBC90 Instruction Manual.indd 5
5
4/06/12 3:02 PM