COOLING SYSTEM
6.1.2.
CHANGING THE COOLANT
DRAINING
NOTE Before proceeding with the operations, take a
container of adequate capacity to collect possible coolant
spillage.
•
Loosen the clamp.
•
Slide the hose out.
NOTE Remove the expansion tank plug to let the coolant
flow out.
•
Drain the system.
FILLING
•
Refit the hose.
•
Secure it with clamp.
•
Remove the central inspection cover.
•
Remove the rubber cap.
•
Slacken bleed valve and fit a tube, set the other end of
tube in a container.
•
Top up expansion tank with coolant, see (COOLANT),
until level reaches approximately "MAX" mark.
•
Bleed any air, tighten the valve and carry on filling with
fluid up to "MAX" mark.
•
Start the engine and warm it up.
•
Bleed air again and top up.
6 - 4
SCARABEO 500