Instrument Panel Operation - APRILIA Scarabeo 500 Workshop Manual

SCARABEO 500
2.1.6.

INSTRUMENT PANEL OPERATION

Turn the ignition key to
segments activate (in this way a check routine of the
components is performed) and the last function set before
vehicle stopped is displayed.
NOTE The Service icon on the LCD turns on after the first
1000 km (621 mi) and then every 10000 km (6214 mi). When
set Service mileage is 300 km (186 mi) away, the Service
icon starts blinking after the check routine performed at start-
up and blinks for about 5 seconds. As soon as set mileage is
reached, the icon stays on permanent until the vehicle is
Serviced.
The various functions are selected and then displayed
pressing the (MODE) button (1) located among the controls
on the left side of handlebar. Segments of the multifunction
LCD are:
•
digital clock (3),
•
odometer indicator (4),
• unit of measurement expressed in km (5),
•
unit of measurement indicator expressed in miles (6),
•
trip meter indicator (7),
•
service warning indicator (8),
•
fuel level indicator (9)
The diagram shows the sequence of available functions:
Pulse means pressing the key and holding it for a certain
time between 0.5 sec and 3 sec.
STARTING STATE
When key is turned on, the instrument panel shows the last
selected quantity.
SETTING THE TIME
From the odometer function, hold the MODE button for more
than 3 seconds to enter time setting mode.
For safety reasons, this should be performed with vehicle
stopped, i.e. when vehicle speed equals zero.
When entering the hour setting mode, the display will switch
off two digits; the other two are the ones being set and will
increase on each pulse of the MODE button.
Press again the button for more than 3 seconds to enter
minute setting mode, in this case the two digits for hours are
switched off and the remaining two will increase on each
pulse of the MODE button.
If you press the button for more than 3 seconds, display
goes back to hour setting mode.
If no key is disturbed for 3 seconds, the display automatically
goes back to the state set before entering setting mode. The
marks dividing hours and minutes will flash when in setting
mode.
, on the multifunction LCD all
GENERAL TECHNICAL INFORMATION
2 - 15