Configuring The Time And Recording Time Display; Configuring Sequence Time; Changing The Video-Out Resolution; Restoring The System's Resolution If You See A Blank Screen - Lorex ECO 2 Instruction Manual

3 In the Covert drop-down menu, select
Enable.
4 Click Apply to save your settings.
Configuring the Time and
Recording Time Display
To add/remove the time stamp in the
system display:
1 In the Live Time and Record Time
drop-down menu, select enable or disable.
2 Click Apply to save your settings.

Configuring Sequence Time

Sequence time refers to the amount of
time a channel appears on the screen
before changing to a different channel
when the DVR is in Sequence Mode. For
example, when Sequence Mode is on,
channel 1 is shown for several seconds
before switching to channel 2.
To configure the sequence time:
1 Click the Output tab.
2 Click the SEQ Dwell time field and enter
the time channels remains on-screen
before changing to another channel.
3 Click Apply to save your settings.

Changing the Video-out Resolution

1 Click the Output tab.
34
SEQ Dwell time
2 Click the drop-down menu beside VGA
Resolution and select the output
resolution.
3 Click Apply to save your settings.
4 Right-click repeatedly to exit all menus.
The DVR prompts you to restart. Click OK.
5 The DVR restarts and asks you to confirm
the new resolution. Click Yes to confirm or
No to revert to the old resolution. If you do
nothing, the DVR will revert to the last
selected resolution and restart.
NOTE: If you select a resolution that is
greater than what your monitor
supports, you may see a blank
screen when your DVR restarts. If
this occurs, do not do anything and
wait until the DVR restarts. If the
screen remains blank, press and
hold the Stop button (
panel of the DVR until the DVR
restarts. Your system resolution will
default to 1024 x 768. 16-channel
only: this method does not work if
the monitor is connected using
HDMI.
Restoring the System's Resolution
if you see a Blank Screen
If you see a blank screen on your
monitor after turning on your system,
the DVR's output resolution may be
higher than what your monitor
supports. Follow the steps below to
restore the DVR's default resolution to
1024 x 768.
NOTE: 16-channel only: this method does
not work if the monitor is connected
using HDMI.
To restore the DVR's default
resolution:
1 Ensure the power and video cables are
properly connected.
2 Press and hold the Stop button (
front panel of the DVR until the DVR

) on the front

) on the