Appendix L: Replacing the Hard Drive
The system comes with a pre-installed 3.5" SATA hard drive. You can expand the 4/
8-channel models with a replacement single hard drive up to 2 terabyte (TB). The
16-channel model has two hard drive bays and can be expanded with a maximum of two 1
terabyte (TB) hard drives (for a maximum storage space of 2TB).
NOTE: It is recommended to use surveillance or security-certified hard drives, which are
designed to be reliable over long periods of time while recording 24/7. Security-certified
hard drives are available at
Removing the Hard Drive
Make sure that the power cable has been disconnected before changing the
hard drive.
To remove the hard drive:
1
Remove the screw from each side panel and rear panel (x3) of the cover.
NOTE: The 16-channel model has 4 rear panel screws and 2 screws on each side panel.
2
Gently slide the cover away from the rear panel and lift off. Be careful of sharp edges.
3
Disconnect the power and data cables.
4
Remove the screws from the mounting brackets.
www.lorextechnology.com
Appendix L: Replacing the Hard Drive
131