Restoring Default Settings; Configuring Event Settings - Lorex ECO 2 Instruction Manual

Remote Viewing Using a Web Browser

Restoring Default Settings

To restore the system's system defaults:
1 Click the Remote Setting tab, and click Advanced>Load Default.
2 Select the menus that you wish to restore to factory defaults.
3 Click Save to restore system defaults for the selected items.

Configuring Event Settings

The Event Settings tab allows you to configure how the system behaves when a system
event occurs (e.g.hard drive error, video loss). This is useful if you want your DVR to notify
you if there is a potential system problem.
To configure the system event settings:
1 Click the Remote Setting tab, and click Advanced>Events.
2 Configure the following:
• Event Type: Configure the type of event that triggers the system to send an alert.
• Enable: Select Enable to activate the system to notify you if an event occurs.
• Buzzer: Select OFF to enable/disable the system buzzer or select the duration of the system
buzzer after an event occurs.
• Show Message: Select the checkbox to enable the system to display a warning message when
an event occurs.
• Send Email: Select the checkbox to enable email notifications. Email notification must be
enabled.
• Alarm Out: Enable or disable the alarm out panel.
• Latch Time: Configure the system latch time after an event occurs.
3 Click Save to save changes.
84