Dell PowerVault 775N Installation And Troubleshooting Manual page 54

2. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
3. Remove the cover (see
4. Disconnect all expansion-card cables.
5. Remove the expansion-card cage (see
6. Position the expansion-card cage so that the riser board lies horizontally on your work surface.
7. Open the expansion-card latch (see
8. Install the expansion card (see
a. Position the expansion card so that the card-edge connector aligns with the expansion-card connector on the
expansion-card riser board.
b. Insert the card-edge connector firmly into the expansion-card connector until the card is fully seated.
c. When the card is seated in the connector, close the expansion-card latch (see
The card guide latch closes automatically as the card is seated in the connector.
Figure 6-4. Installing an Expansion Card
9. Replace the expansion-card cage (see
10. Reconnect all expansion-card cables, including those for the new card.
"Removing the Cover" in "Troubleshooting Your System").
"Removing the Expansion-Card
Figure 6-4) and remove the filler bracket.
Figure 6-4).
"Replacing the Expansion-Card
Cage").
Figure 6-4).
Cage").