Dell PowerVault 775N Installation And Troubleshooting Manual page 16

Invalid configuration information -
please run SETUP program
Invalid NVRAM configuration, resource
re-allocated
Invalid SCSI configuration
SCSI cable detected on connector SCSIB
of the SCSI backplane, daughter card
not present
Keyboard controller failure
Keyboard clock line failure
Keyboard data line failure
Keyboard failure
Keyboard stuck key failure
Memory address line failure at address,
read value expecting value
Memory double word logic failure at
address, read value expecting value
Memory high address line failure at
start address to end address
Memory high data line failure at start
address to end address
Memory odd/even logic failure at start
address to end address
Memory write/read failure at address,
read value expecting value
Memory parity failure at start address
to end address
Memory parity error at address
No boot device available
No boot sector on hard- disk
No PXE-capable device available
No timer tick interrupt
Not a boot diskette
PCI BIOS failed to install
Plug & Play Configuration Error
Incorrect configuration
settings in System Setup
program; NVRAM_CLR
jumper is installed; faulty
system battery.
System configuration data
has been ignored.
A SCSI cable is connected
to the channel B connector
on the SCSI backplane
board; SCSI backplane
daughter card is not
installed.
Faulty keyboard controller;
faulty system board.
Loose or improperly
connected keyboard cable;
faulty keyboard; faulty
keyboard controller.
Faulty or improperly
installed memory modules.
Faulty or improperly
installed memory modules.
Faulty or missing
CD/diskette drive
subsystem, hard drive, or
hard-drive subsystem.
No operating system on
hard drive.
<F12> pressed during
POST and no PXE devices
are detected.
Faulty system board.
No operating system on
diskette.
Loose cables to expansion
card(s); faulty or
improperly installed
expansion card.
Error encountered in
Check the System Setup configuration settings
(see "Using the System Setup Program" in the
User's Guide). Remove the NVRAM_CLR jumper
(see Figure A-2 for jumper location). If the
problem persists, see "Troubleshooting the
System Battery" in "Troubleshooting Your
System."
Check the System Setup configuration settings.
See "Using the System Setup Program" in the
User's Guide.
If a cable is connected to the SCSIB backplane
board connector, the SCSI backplane daughter
card must be installed. Install the backplane
daughter card (see "Installing a SCSI
Backplane Daughter Card" in "Installing
Drives").
See "Getting Help."
See "Troubleshooting the
"Troubleshooting Your System."
See "Troubleshooting System
"Troubleshooting Your System."
See "Troubleshooting System
"Troubleshooting Your System."
Use a bootable diskette, CD, or hard drive. If
the problem persists, see
Diskette Drive," "Troubleshooting a CD
and "Troubleshooting Hard
"Troubleshooting Your System."
Check the hard-drive configuration settings in
the System Setup program (see "Using the
System Setup Program" in the User's Guide).
Check the configuration settings in the System
Setup program for the NICs (see "Using the
System Setup Program" in the User's Guide). If
the problem persists, see
NICs" in "Troubleshooting Your System."
See "Getting Help."
Use a bootable diskette.
Ensure that all appropriate cables are securely
connected to the expansion cards. If the
problem persists, see "Troubleshooting
Expansion Cards" in "Troubleshooting Your
System."
Install the NVRAM_CLR jumper and reboot the
Keyboard" in
Memory" in
Memory" in
"Troubleshooting the
Drive,"
Drives" in
"Troubleshooting the