Replacing Srx5600 Services Gateway Spcs - Juniper SRX5600 Hardware Manual

Related
Documentation

Replacing SRX5600 Services Gateway SPCs

Copyright © 2014, Juniper Networks, Inc.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
Insert the other end of the cable into the destination port.
5.
Repeat the previous steps for any additional cables.
6.
If the component is offline (its failure indicator LED is lit), use one of the following
7.
methods to bring it online.
To bring an IOC or MPC online:
Press and hold the corresponding IOC or MPC online button on the craft interface
until the green
OK
Issue the following CLI command:
user@host>request chassis fpc slot slot-number online
For more information about the command, see Junos OS System Basics and
Services Command Reference at
To bring a port module online:
Press the port module online button until the PIC LED lights green. Use a
narrow-ended tool that fits inside the opening that leads to the button.
Issue the following CLI command:
user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see Junos OS System Basics and
Services Command Reference at
The normal functioning indicator LED confirms that the component is online. You can
also verify correct IOC functioning by issuing the
PIC functioning by issuing the
Connecting Network Cables to SRX5600 Services Gateway IOCs and Port Modules
on page 67
To replace an SPC, perform the following procedures:
Removing an SRX5600 Services Gateway SPC on page 162
1.
Installing an SRX5600 Services Gateway SPC on page 163
2.
Chapter 13: Replacing SRX5600 Services Gateway Hardware Components
LED next to the button lights steadily, in about 5 seconds.
www.juniper.net/techpubs/
www.juniper.net/techpubs/
show chassis fpc
show chassis fpc pic-status
.
.
command or correct
command.
161