Juniper SRX5600 Hardware Manual page 30

SRX5600 Services Gateway Hardware Guide
12
card (IOC), but allows greater flexibility in adding different types of Ethernet ports to
your services gateway. MPCs and MICs are similar in form and function to Flex IOCs
and port modules. However, the two use different form-factors, so you cannot install
port modules in an MPC, nor can you install MICs in a Flex IOC.
For all interface card types, the card assembly combines packet forwarding and Ethernet
interfaces on a single board. The interface cards interface with the power supplies and
Switch Control Boards (SCBs).
You can install interface cards in any of the slots that are not reserved for SCBs. If a slot
is not occupied by a card, you must install a blank panel to shield the empty slot and to
allow cooling air to circulate properly through the services gateway.
Figure 5 on page 12 shows typical IOCs supported on the services gateway.
Figure 5: Typical IOCs
Figure 6 on page 13 shows a Flex IOC with two typical port modules installed.
Copyright © 2014, Juniper Networks, Inc.