Table of Contents
Advertisement
If the machine is set to its default setup, the DEFAULT SETUP button
illuminates. Otherwise it is off.
To set the machine to its default setup:
1. Press the DEFAULT SETUP button.
The DEFAULT SETUP button LED blinks and the following message
appears on the LCD display:
2. Press the DEFAULT SETUP button a second time to recall the default
setup.
The DEFAULT SETUP button stops blinking and no longer illuminates, the
TAKE button blinks and the following message appears on the LCD display:
3. Press the TAKE button to confirm the action or press the ESC button to
cancel the operation.
If the DEFAULT SETUP was recalled, the DEFAULT SETUP button
illuminates.
8.7 Choosing the FOLLOW or the BREAKAWAY Modes
When the VS-3232A functions in the:
FOLLOW-System mode, the VS-3232A switches with other 32x32 or
16x16 matrix switchers, implementing the same action simultaneously
BREAKAWAY-from-System mode, the VS-3232A functions
independently, implementing an action as a standalone unit that is
independent of the other units connected
The VS-3232A unit will function in the FOLLOW-System mode if at least
one other VS-3232A unit is set to the FOLLOW-System mode and these units
interconnect via an RS-232 and/or RS-485 communication line.
To set the VS-3232A unit to function in the FOLLOW-System mode:
1. Make sure that DIP 5 is set to ON. If it is not set to ON, when pressing the
FOLLOW button, the following message appears:
1 See section 7.1
Operating Your Video Matrix Switcher
6
7 8
;
=
5
9
<"*
>
?
9
:
1
35
Advertisement
Table of Contents
