Controllers - Kitchen Deluxe Installation - Rinnai Infinity VT16 REU-VR1620WG Installation Manual

Controllers - Kitchen Deluxe installation

1. Determine the most suitable position for the controller.
2. Use the wall mounting bracket as a template to mark and drill three holes, locating the
cable access hole as shown below.
3. Fix the mounting bracket to the wall using the appropriate fixings.
4. Run the water controller cable through the hole in the wall.
5. Carefully remove face plate from the controller, using a screwdriver as shown below.
6. Connect the controller cable to the kitchen water controller. At this point cables from other
controllers (if fitted) may also be connected to the kitchen water terminals, eliminating the
need for multiple cable runs directly to the water heater. Feed excess cable lengths into the
wall cavity to avoid pinching of cables between the wall and the water controllers.
7. Fasten water controllers to wall mounting bracket. Avoid the use of impact drills and over-
tightening of fixings as this may damage the controllers.
8. Remove the protective plastic from the controller face and replace the face plate.
Rinnai New Zealand Ltd.
128
Continuous Flow Water Heater Installation Manual:
17
03-11