Controllers - Universal Installation - Rinnai Infinity VT16 REU-VR1620WG Installation Manual

Controllers - Universal installation

Fitting the Universal (Compact) Controller
1. Determine the most suitable position for the controller.
2. Drill three holes as shown (Fig.1 and Fig.2) for the securing screws and one to provide
cable access.
3. When running cable through the access hole ensure the connector end of the cable is
located nearest to the controller (Fig.2).
4. Carefully remove the face plate from the controller using a screwdriver (Fig.3).
5. Fix the controller to the wall using appropriate fittings as shown (Fig.4).
6. Remove protective plastic from the controller face as shown (Fig.4) and replace the face
plate.
90
Fig.1
Optional programming of the Universal controller
Step 1
Are four controllers connected? No, refer step 2. Yes, you will need to
activate the fourth controller as follows:
1. For the controller in the kitchen only, press and hold the 'Transfer' and
2. Check display on all four controllers is displaying a temperature when
1. For the controller in the kitchen only, press and hold the 'Transfer' and
Step 2
2. When the controller fitted in the kitchen is switched on it will be possible
If the kitchen controller is replaced or swapped repeat the programming procedure.
Rinnai New Zealand Ltd.
Controller Cable
Connector
Fig.2
'On/Off' buttons simultaneously until a beep is heard (approximately five
seconds).
switched on. If any controller displays two dashes, repeat above step.
'On/Off' buttons simultaneously until a beep is heard (approximately five
seconds).
to select temperatures higher than 50 °C (at this controller). If not repeat
above step.
Face Plate
Fig.3
Continuous Flow Water Heater Installation Manual:
16
Film
Face Plate
Screw
Fig.4
03-11