Function 3: Extension Programming; Function 30: Station Move - ESI 50L Administrator's Manual

ESI-50L Programming Manual

Function 3: Extension programming

This section provides programming for extensions and department groups.
Important: Where any gray shading (■) appears in an example, it represents values either unavailable to the function
or unused in the particular example.

Function 30: Station move

This feature allows the Installer or Administrator to exchange the extension numbers of two extensions. It is used
only for exchanging extensions — not guest mailboxes or departments.
Important: Before you use this function on two extensions, make sure they're both idle at the time.
Along with the extension numbers, this function also will exchange the following parameters (depending on
station type):
• Extension name and other assignments (including of the Operator to extension 0 from Functions 31 and 32).
• Mailbox information (personal greeting, notification, schedules).
• Programmable feature keys.
• Personal Dex.
Function 30 has the following limitations:
• Mailboxes cannot be exchanged. Instead, your Installer must perform flexible number assignment.
• Both extensions must be of the same "type" — i.e.., analog to analog, digital to digital — as shown in the
following table:
From . . .
Digital phone
Analog extension
Digital phone
Fax, modem, door, ringer, server,
RFID Reader
To use this feature:
1. Enter Installer programming through a Digital or IP Feature Phone and go to Function 30.
2. Enter the first extension and press #.
STATION MOVE
1ST EXT: 104
3. Enter the second extension and then press #.
X1044 J SMITH
2ND EXT: 105
(Continued)
1
Your ESI Reseller must use an Installer function to change the numbers of these types of extensions.
Function 4: Auto attendant programming
To . . .
Digital phone
Analog extension
Analog extension
Any type of phone
Function 30 allowed?
Yes
Yes
1
No
No
D.1