Dual Chargers; Cleaning The Chargers - Alcatel OmniPCX Office IPTouch MIPT 300 User Manual

6.3

Dual Chargers

The Dual Charger is a two-slot desktop charger. Two different models are available to charge MIPT 300 and MIPT 600. The Dual
chargers are designed to charge the MIPT and a spare Battery Pack. The models are not interchangeable.
Place the handset face forward into the Dual Charger front slot. Place a spare Battery Pack in the rear slot, charging contacts
down. The front slot takes charging precedence. The Battery Pack in the rear slot will begin charging when the handset in the
front slot is fully charged or when the front slot is empty.
Indicator light.
When the handset or Battery Pack is seated correctly, the corresponding indicator light will come on. A bright indicator means
the Battery Pack is charging, a dim indicator means the Battery Pack is waiting to charge. The indicator light will not come on
when the handset is incorrectly seated, the slot is empty or when the Dual Charger has no power applied. If the indicator light
is off or flashing, it means the handset or Battery Pack is incorrectly seated. Remove the handset or Battery Pack and reinsert.
If the LED continues to blink or starts blinking at any time during the charging process, it indicates that there is a problem with
the Battery Pack that makes it unusable. Do not continue to charge the Battery Pack. Dispose of it properly and do not attempt
to use it in the MIPT. Do not attempt to open or repair a defective Battery Pack. Contact your service representative for
assistance.
The indicator light will turn off when charging is complete. Full charging is accomplished in approximately two hours for either
slot.
Charge Complete.
When the MIPT is fully charged, Charge Complete will display.
Batteries and chargers
6.4 The Gang Charger - only on Mobile IPTouch 600
The Gang Charger is designed to charge four Nickel Metal Hydride (NiMH) Battery Packs simultaneously. Full charging is
accomplished in approximately one and a half hours. Chargers operate in a 50° to 85° F (10° to 30° C) environment. Do not
expose them to freezing temperatures or direct sunlight.
The Gang Charger is shipped with the appropriate power supply for the site's location. Place the Gang Charger on a flat,
horizontal surface. Plug the power supply into the Gang Charger and into an appropriate wall outlet.
Using the GC
Insert the Battery Pack into one of the four charging bays so that the Battery Pack contacts meet the charging bay contacts. The
LED above the charging bay will turn on to indicate that charging is in progress. Complete charging occurs in one and a half to
two hours. The Battery Pack is partially charged in five minutes. When charging is complete the LED will turn off. Lift the
Battery Pack out of the charging bay.
Blinking LED
If the LED starts blinking as soon as the Battery Pack is inserted, the Battery Pack may be improperly seated. Lift it out and
reinsert. If the LED continues to blink or starts blinking at any time during the charging process, it indicates that there is a
problem with the Battery Pack that makes it unusable. Do not continue to charge the Battery Pack. Dispose of it properly and
do not attempt to use it in the MIPT. Do not attempt to open or repair a defective Battery Pack. Contact your service
representative for assistance.

Cleaning the Chargers

6.5
Clean the Chargers by wiping the surface with a clean, water-dampened cloth or paper towel. A mild detergent solution may be
used. Be sure to wipe away any detergent residue with a plain water dampened cloth. DO NOT IMMERSE THE CHARGER IN
WATER OR OTHER LIQUID. DO NOT POUR LIQUIDS INTO THE SLOT.
The Battery Pack contacts on the MIPT may be cleaned with isopropyl (rubbing) alcohol applied with a Q-tip, cloth, or paper
towel. Do not push or pull the exposed Battery Pack contacts.
Important information
• Never use non-MIPT charging units as they could damage the Battery Pack.
• Only use the original plug-in power adapter for the Chargers.
• Do not immerse the Battery Pack in water or throw into the fire.
• Do not throw away the Battery Pack with your domestic waste. Take used Battery Packs to an appropriate collection point for
recycling or send them back to your supplier or servicing agent.
• Replacement Battery Packs are available from your supplier or servicing agent.
24