Cruise Control - Triumph Trophy Handbook

General Information
The warning light will flash twice every
second during system re-calibration.
10:08
ODO
1
chdo
1. TES warning light
To allow the system to calibrate correctly, the
following procedure must be adhered to:
• Turn the ignition on. Do not start the
engine.
• Wait for the warning light to stop flashing
indicating that damper adjustment motor
calibration is complete.
• Start the engine. If the warning light
resumes flashing, the pre-load motor is
being calibrated.
• Wait for the warning light to stop flashing
before riding the motorcycle.
Failure to follow this procedure will cause the
re-calibration to be halted and the warning
light to remain lit.
In this case the warning light will extinguish
once the re-calibration is next allowed to
complete.
58

Cruise Control

N
26°C
Cruise control must only be used where
TRIP 1
you can drive safely at a steady speed.
0
Cruise control should not be used when
MPH
144.2 riding in heavy traffic, on roads with
sharp/blind bends or when they are
1892
slippery.
Using cruise control in heavy traffic, on
roads with sharp/blind bends or when they
are slippery, may result in loss of
motorcycle control and an accident.
This Triumph
operated within the legal speed limits for
the particular road travelled. Operating a
motorcycle
potentially dangerous since the time
available to react to given traffic situations
is greatly reduced as speed increases.
Always reduce speed in consideration of
weather and traffic conditions.
Warning
Warning
motorcycle should be
at high speeds can be