Installing The Monitor; Installing The Camera - Uniden G1410 Owner's Manual

Installing the Monitor

Out of the box, your monitor has enough power to be used when you place and
install the cameras. You can check the camera placement and angle before you
physically screw the camera stands into place.
After you have installed the cameras and set up the monitor, plug the DC 5V AC
adaptor power output cable into the 5V POWER input of the cradle or monitor. Plug
the power plug into a wall outlet or surge protector.
If you are powering the monitor through the cradle, insert the monitor into the cradle
at this point. Press firmly to ensure a good connection. The LED on the side panel
turns red to indicate charging is in progress. The

Installing the Camera

You can mount the camera with the stand on the bottom (for a flat surface such
as a tabletop), on the side (for a wall), or on the top (for the ceiling). When you are
positioning the camera, you might want to bring the monitor along; it's much easier
to get the camera into the right position when you have the monitor handy.
Mount the Camera Base
The following tools are required:
• Electric Drill
• 5mm Drill Bit
• No. 2 Phillips Screwdriver
1. Hold the base of the camera stand where you want to mount it and mark the
location of the screw holes.
2. Drill holes using the 5mm drill bit.
3. Insert anchors.
4. Use the included screws to attach the base to the wall or ceiling. You can also
screw the base into a flat surface such as a tabletop if needed.
Before attaching the camera, tug gently on the stand to make sure it is securely in
place.
icon displays.
7