Toshiba TECRA A9 Series Maintenance Manual page 249

4 Replacement Procedures
NOTE: The following steps describe how to disassemble the HDD assembly, however, do
not disassemble if the HDD is working properly.
5. Place the HDD assembly on a flat surface, and remove the following screws.
•
M3×4C
6. Separate the HDD and HDD Holder.
CAUTION: Do not apply pressure to the center of the HDD assembly. It may damage
the HDD assembly. Hold the HDD assembly by its corners.
HDD
Figure 4-6 Separating the HDD and HDD holder
4-14 [CONFIDENTIAL] TECRA A9/TECRA S5/TECRA P5/Satellite Pro S200 Maintenance Manual (960-633)
FLAT HEAD screw
M3×4C FLAT HEAD
×4
M3×4C FLAT HEAD
4.5 HDD
HDD Holder