Mdc Module; Removing The Mdc Module - Toshiba Satellite L350 Maintenance Manual

4 Replacement Procedures

4.5 MDC Module

Removing the MDC Module

Remove the MDC Module (Modem Daughter Card) according to the following procedures
and Figures 4-10, after checking that the computer is turned off in boot mode.
CAUTION: Remove the MDC module after turning off the computer. If this is violated,
the computer or MDC module can be damaged.
1. Remove the two M2x3 black flat head screws securing the MDC module.
2. Left the MDC module and disconnect it from CN6 on the system board.
3. Disconnect the MDC cable from connector J2 on the MDC card.
CAUTION: Do not touch the connectors on the MDC module or in the computer.
Contaminated connectors can cause MDC module failures.
4-24
MDC card
J1
Figure 4-10 Removing the MDC module
Satellite L350/ Satellite Pro L350/ EQUIUM L350/ SATEGO L350 Maintenance Manual
M2 5x2 6 black flat head screw . .
J2
MDC cable
CN6

4.5 MDC Module