HYT TC700 Manual page 27

activated only when the matching 2-Tone/5-Tone/HDC2400
Likewise, your signals will be received only by parties using the same 2-Tone/5-Tone/
TM
HDC2400 signals.
● The LED glows red during transmission; when the transmission is co
LED solidly glows orange until the preset time elapses.
● The LED glows green during decoding
elapses to indicate successful decoding.
Signalling AND / OR Logic
Signalling "AND"/"OR" sets the audio unmute condition for any channel programmed with
CTCSS/DCS or Opt Signalling (2-Tone/5-Tone/HDC2400
CTCSS/DCS AND 2-Tone/5-Tone/DTMF/HDC2400
The squelch opens only when both CTCSS/DCS and Opt Signalling (2-Tone/5-Tone/
TM
DTMF/HDC2400 ) are received and matches the preset one on selected channel.
CTCSS/DCS OR 2-Tone/5-Tone/DTMF/HDC2400
The squelch opens when either CTCSS/DCS or Opt Signalling (2-Tone/5-Tone/DTMF/
TM
HDC2400 ) is received and matches the preset
PTT ID
PTT ID (BOT/EOT/Both) is used to access and release repeaters and telephone systems.
BOT ID (Beginning of Transmission):
The radio transmits the ID code (2-Tone/5-Tone/HDC2400
transmission, when the [PTT] key is pressed.
EOT ID (End of Transmission):
The radio transmits the ID code (2-Tone/5-Tone/HDC2400 ) just before it ends
transmission, when the [PTT] key is released.
B oth:
The radio transmits the ID code when it begins/ ends transmission.
TM
, and flashes orange until the preset time
TM
).
TM
:
TM
:
one on selected channel.
TM
) immediately after it begins
TM
27
signals are received.
mpleted, the