HYT TC700 Manual page 26

Low atter War ing B y
Low Battery Warning alerts you to recharge or replace the battery. When the batter
v oltage becomes low, radio LED will flash red and three Beeps sound every 30 seconds,
indicating to rech arge or replace the battery with a new one.
Safety Check
When receiving a safety check call, the radio will emit an alert tone in preprogrammed
time. Press any key to respond and cancel the alert, otherwise, the radio will automatically
enter emergency mode.
CTCSS/DCS Signalling
CTCSS/DCS may have been programmed on a channel to ignore unwanted calls from
other parties on the same channel. When CTCSS/DCS signalling is set, the squelch will
be opened only when signals containing the matching tone
a llows you to ignore (not hear) these calls. Likewise, your signals will be received only by
parties using the s ame CTCSS/DCS signalling.
Although it may seem like you have a private channel while using CTCSS/DCS signalling,
other parties can still hear your calls if they use the same tone or code.
D TMF Signalling
DTMF Signalling is enable
programmed on a channel, press the programmable key (Call 1, Call 2) to transmit DTMF
code.
●LED glows red during transmission and goes out when transmission ends.
2-Tone/5-Tone/HDC2400
2-Tone/5-Tone/HDC2400
TM
5-Tone/HDC2400
(Call 1, Call 2) to transmit 2-Tone/5-Tone/HDC2400
When 2-Tone/5-Tone
n
d/disabled by your dealer. When DTMF signaling is
TM
Signalling
TM
signalling is enabled/disabled by your dealer. When 2-Tone/
signalling is programmed on a channel, press the p
TM
/HDC2400 is set on a channel, the preset functions will be
or code are received. This
TM
signal.
26
y
rogrammable key