Table of Contents
Advertisement
HOW TO OPERATE THE MACHINE
How To Operate the Squeegee
("S Class" models only)
The squeegee wipes the floor while the vacuum motor
removes the dirty solution from the floor. Use your right
hand to lower or raise the squeegee handle. To operate
the squeegee, follow this procedure:
1. To lower the squeegee and start the vac motor move
the squeegee lever to the right and down. See figure
#15.
2. To raise the squeegee, lift the squeegee lever up.
See figure #16.
Note: The center position lets the vac motor continue
to run with the squeegee off the floor to avoid drips.
How to Fill The Solution Tank
CAUTION: Make sure water or solution
The solution tank lid is at the front. To fill the solution tank
follow this procedure:
1. Remove the solution tank lid. See figure #18
2. Fill the solution tank with water.
3. Add a cleaning chemical to the water. for the
correct amount, follow the directions shown on the
container.
WARNING:
Water solutions or cleaning materials
used with this type of machine can leave
wet areas on the floor surface. These
areas can cause a dangerous condition
for the operator or other persons.
Always put CAUTION signs near the
area you are cleaning.
WARNING:
Machines can ignite flammable materials
and vapors. Do not use with or near
flammables such as gasoline, grain
dust, solvents, and thinners. Only use a
cleaning concentration recommended by
the chemical manufacturer.
WARNING:
Clarke Technology recommends a
maximum water temperature of
120°F(49°C)
4. Replace the solution tank lid.
Page
-18-
does not enter the opening for
the vacuum motor See figure
#17.
CLARKE TECHNOLOGY Operator's Manual -Encore S28/L28/S33/L33/S38/L38
Figure #15
Figure #16
Figure #17
Figure #18
Advertisement
Table of Contents
