Table of Contents
Advertisement
HOW TO OPERATE THE MACHINE
How To Operate The Scrub Deck
Brushes or pads are used along with a solution mix to agitate
and scrub the floor. Many different types of brushes or pads are
available (see accessory section) for different scrubbing
applications. See your Clarke representative for proper brush or
pad requirements. To operate the brushes or pads follow this
procedure:
1. Install the brushes or pads and replace the brush
housings. See section on How To Install the Brushes Or
Pad Drviers.
2. Fill the solution tank. See section on How To Fill The
Solution Tank.
3. Lower the brush deck by pressing the Up/Down brush
switch to the down position (figure 15, A). This will place
the brush deck in the normal scrub position.
4. If additional brush pressure is desired, such as when
stripping or cleaning a heavily soiled floor, more pressure
can be applied. After the brush deck has been lowered to
the floor, additional brush pressure can be applied by
pressing and holding the jog button switch (figure 16, B)
until the desired brush pressure is reached or until the
brush deck stops moving downward. To reposition the
brush pressure to normal scrub, press the brush up/
down switch to the up position and after the brush deck
has completely raised, then return the switch to the down
position for normal scrub.
5. The brushes/pads and solution will start when the
traverse control handle (figure 16, C) is pushed forward
or pulled to the rear. Note: The brushes/pads and
solution will only operate when the brush deck is in the
down position and the traverse control handle is pushed
forward or pulled to the rear.
6. Stop the brushes/pads and solution flow by releasing the
traverse control handle, or raising the brush deck to the
full up position.
How To Operate the Squeegee
("S Class" models only)
The squeegee wipes the floor while the vacuum motor removes
the dirty solution from the floor. Use your right hand to lower or
raise the squeegee handle. To operate the squeegee, follow
this procedure:
1. To lower the squeegee and start the vac motor move the
squeegee lever to the right and down. See figure #17.
2. To raise the squeegee, lift the squeegee lever up. See
figure #18.
Note: The center position lets the vac motor continue to run
with the squeegee off the floor to avoid drips.
Page
-14-
®
Clarke
Operator's Manual -Encore S28XP/S33XP/S38XP
A
Figure #15
C
B
Figure #16
Figure #17
Figure #18
Advertisement
Table of Contents
