Toshiba TECRA S4 Maintenance Manual page 133

3.3 Check of the RAID configuration
NO DRIVE for one drive is displayed
When "NO DORIVE" is displayed and the HDD is connected to the port, follow the
procedures below to check the HDD failure. When the HDD is not connected to the
port, removing of the drive causes the failure. It is not necessary to repair.
(1) Install a new HDD.
When "NO DORIVE" is still displayed, It is judged that the MB or cable fails.
(2) When a new HDD is recognized, It is judged that the HDD removed is failed.
Specify the reason by using the Independent Utility.
TOSHIBA RAID / RAID Information Display
Copyright(c) 2005 TOSHIBA CORPORATION. All Rights Reserved.
Level
LD0 RAID-1
Write cache
MBR Protection
S.M.A.R.T
Port Assgn Status
0 LD0-0 ONLINE
1
< RAID : not OPTIMAL >
TECRA S3 Maintenance Manual (960-532)
Status Capacity
DEGRADE xxGB
: Enable
: Disable
: Enable
Size
xxGB
NODRIVE xxGB
Rev xx.xx.xxxx
Model
FUJITSU----------
FUJITSU----------
[CONFIDENTIAL]
3 Tests and Diagnostics
Rev
xxxxxxx
xxxxxxx
3-15