Shift Cable Installation; Alpha Models - Drive Unit Not Installed - Mercury Alpha Installation Manual

Shift Cable Installation

Alpha Models - Drive Unit Not Installed

We recommend the use of a Quicksilver remote control and cable. Refer to Mercury
Precision Parts / Quicksilver Accessories Guide for selection. However, if a control other
than Quicksilver is to be used, control must provide a shift cable travel (at the shift plate end)
of 2-7/8 in. (73 mm) to 3-1/8 in. (80 mm) with a 15-20 lb. (6.8-9 kg) load applied to the cable
end guide.
NOTE: On engines with Alpha drives, the measurement indicated above can be taken by
installing the remote control shift cable and using the shift assist assembly (provided) to
place the proper load on the shift cable.
1. Place a mark on the tube against the edge of the cable end guide.
a -
b -
c -
d -
e -
90-860172011
d
a a
Shift Assist Assembly
Remote Control Shift Cable - In FORWARD Gear Position
Edge Of Cable End Guide
Remote Control Shift Cable - In REVERSE Gear Position
Measurement Taken From Mark To Edge Of Cable End Guide:
2-7/8 in. (73 mm) to 3-1/8 in. (80 mm)
GASOLINE STERNDRIVE INSTALLATION MANUAL
e
b
c
a
INDEX
50368
Page 67 of 137