Trim Position Sender Adjustment - Mercury Alpha Installation Manual

GASOLINE STERNDRIVE INSTALLATION MANUAL

Trim Position Sender Adjustment

ANALOG GAUGES
1. Loosen both trim position sender retaining screws.
a -
b -
DO NOT start engine in the following step or damage to sterndrive unit and engine
could result from lack of cooling water.
2. Turn ignition key to RUN position.
3. Trim sterndrive unit to the full DOWN/IN position.
4. Rotate trim position sender as required to show full DOWN/IN position on dashboard
instrument as shown.
a -
5. Tighten retaining screws and turn ignition key to the OFF position.
a -
b -
Page 100 of 137
b
Retaining Screws
Trim Position Sender
Trim Gauge Needle
b
Retaining Screws
Trim Position Sender
a
CAUTION
a
a
INDEX
71220
71671
71220
90-860172011