Shift Cable; Serpentine Belt Inspection - Mercury 92‑813054A2 Manual

Shift Cable

1. Lubricate the pivot points and guide contact surfaces.
a
Tube Ref No.
SAE Engine Oil 30W
80

Serpentine Belt Inspection

Inspecting the belts with the engine running may cause serious injury or death. Turn off the engine and remove the ignition
key before adjusting tension or inspecting belts.
All drive belts must be periodically inspected for proper tension and condition. Belts that show signs of wear such as cracking,
fraying, or glazing of the belt surface should be replaced.
If the serpentine belt needs to be replaced, consult your Mercury Diesel authorized repair facility.
1. Inspect the belt for proper tension and for the following:
• Excessive wear
• Cracks
NOTE: Minor, transverse cracks (across the belt width) may be acceptable. Cracking that results in the loss of belt
material or longitudinal cracks (in the direction of belt length) that join transverse cracks are not acceptable.
• Fraying
• Glazed surfaces
2. Check the operation of the automatic tensioner and associated components.
a. Position a suitable tool on the automatic tensioner pulley bolt.
90-8M0069748 APRIL 2012
eng
b
13347
Description
Shift cable pivot points and guide contact surfaces
!
Typical inboard model shift cable and transmission linkage
a - Pivot points
b - Guide contact surface
Where Used
WARNING
21062
Section 5 - Maintenance
Part No.
Obtain Locally
Page 71