Table of Contents
Advertisement
2. Plug the AC adaptor plug into DC power Jack at
the rear side of base.
3. Press the power button on the base or remote control to turn the unit on. Switch on the
speakers to play your iPod. Choose the best channel through the "Channel" button at the
rear of the base until the speakers receive the right signal.
4. Press 'Vol+" or 'Vol-' to choose a proper volume level, then you should now be able to take
the speakers freely from room to room without disruption (Subject to its surroundings,
approximately 100 feet in the open area without any interference).
5. If using iPod shuffle or other audio source with 3.5 mm headphone output jack, connect it
to the AUX line in jack on the rear of base. (AUX in will not work when an iPod is docked)
6. Press the power button on the base or remote control to turn off the unit.
TROUBLESHOOTING GUIDE
Should you experience difficulties in the use of this player, please refer to the following chart or
call 1-800-777-5331 for Customer Service.
Symptom
The base does not
switch on (no power)
iPod does not
respond to the
speaker system
Possible problem
AC adaptor is not plugged into a
wall outlet or the connector is not
plugged into the DC jack on the
back of the unit.
Wall outlet is not functioning.
Using no/wrong iPod cradle.
iPod is not installed properly.
Your iPod is locked up.
7
Solution
Plug the AC adaptor into a wall outlet
and plug the connector into the DC
jack on the unit.
Plug another device into the same
outlet to confirm the outlet is working.
Make sure the dock cradle is the
proper fit for your iPod.
Remove your iPod from the dock and
check for any obstruction on the
connectors in the docking and on
your iPod. Then reseat it in the dock.
Please make sure that your iPod is
Advertisement
Table of Contents
