Troubleshooting Guide - Jensen JiMS-190 Owner's Manual

Symptom
The unit does
not respond (no power)
®
iPod does not
dock properly
iPod does not respond ®
to the speaker system
®
iPod does not
charge up
iPod unintentionally
wake up in PAUSE
mode
AM band is too noisy
Sound is distorted
Unit gets warm after
extended play at
high volume

TROUBLESHOOTING GUIDE

Possible Problem
AC Adaptor is not plugged into a
wall outlet or the connector is not
plugged into the power supply jack
on the back of the unit.
Wall outlet is not functioning.
Using no/wrong iPod Adaptor
®
®
iPod does not install properly.
iPod is not installed properly. ®
®
Your iPod is locked up.
iPod is not installed properly. ®
iPod is locked up/ frozen. ®
®
iPod battery has problem.
Unit is in Radio mode
It may be caused during function
switching
The reception at the set location is
poor.
Volume level is set too high.
Sound source is distorted.
This is normal.
13
Solution
Plug the AC adaptor into a wall
outlet and plug the connector into
the supply jack on the unit.
Plug another device into the same
outlet to confirm the outlet is working.
Make sure the dock insert is the
proper fit for your iPod
®
Remove your iPod from the dock
®
and check for obstruction on the
connectors in the dock and on your
iPod . Then reseat it in the dock.
®
Remove your iPod from the dock ®
and check for obstruction on the
connectors in the dock and on your
®
iPod . Then reseat it on the dock.
Please make sure that your iPod is
working properly before docking into
the unit. Please refer to your iPod
manual for details.
®
Remove your iPod from the dock
and check for obstruction on the
connectors in the dock and on your
®
iPod . Then reseat it in the dock.
Please make sure your iPod is
working properly before docking into
the unit. Please refer to your iPod
manual for details.
Select iPod, AUX or Standby mode
for iPod charging
Wait for 3 minutes, iPod will enter
sleep mode automatically
Slightly rotate the unit for the best
reception.
Decrease the volume.
If the iPod original sound source is of
poor quality, distortion and noise are
easily noticed with high-power
speakers. Try a different audio source
such as a music CD.
If you are using an external sound
source like older generation of iPod ,
try reducing the output volume on the
device itself. Also try turning bass
boost OFF or change the EQ setting.
Turn the unit off for a period of time or
lower volume.
®
®
®
®
®