Replacing The Battery - Sun Microsystems Sun Fire X4100 Service Manual

Section 3.12.8, "Replacing the Front Panel Indicator Board" on page 3-44
■
Section 3.12.9, "Replacing the Front I/O Board" on page 3-46
■
Section 3.12.10, "Replacing the Graphics Redirect and Service Processor (GRASP)
■
Board" on page 3-51
Section 3.12.11, "Servicetool FRU Update Procedure" on page 3-53
■
Section 3.12.12, "Replacing a Drive" on page 3-54
■
Section 3.12.13, "Replacing the Drives Backplane" on page 3-57
■
Section 3.12.14, "DIMM Population Rules" on page 3-61
■
Section 3.12.15, "Replacing DIMMs" on page 3-65
■
Section 3.12.16, "Replacing PCI Cards" on page 3-72
■
Section 3.12.17, "Replacing the Motherboard" on page 3-77
■
Section 3.12.18, "Replacing a Power Supply" on page 3-83
■
Section 3.12.19, "Replacing the Power Distribution Board (PDB)" on page 3-86
■
(FRU)
Section 3.12.20, "Replacing the Rear Fan Tray (Sun Fire X4200/X4200 M2 Servers)"
■
on page 3-89
3.12.1

Replacing the Battery

Note – This component is a CRU and can be replaced by anyone.
Supported components and their part numbers are subject to change over time. For
the most up-to-date list of replaceable components for these servers, refer to:
http://sunsolve.sun.com/handbook_pub/Systems
1. Click the name and model of your server.
2. On the product page that opens for the server, click Full Components List to
view a list of components.
Use the following procedure to replace the battery.
1. Power off the server as described in
2. If the server is in a rack, slide it far enough from the rack so that you can
remove the main cover. If you cannot safely view and access the component,
remove the server from the rack.
3. Remove the main cover as described in
page 3-10
(FRU)
(CRU)
.
(CRU)
(CRU)
(CRU)
(CRU)
.
Section 3.4 on page 3-4
Section 3.5 on page 3-6
Chapter 3 Maintaining the Sun Fire Servers
(CRU)
(CRU)
(FRU
(FRU)
or
Section 3.8 on
3-15