Table of Contents
Advertisement
For Parts Call 606-678-9623 or 606-561-4983
Lubrication
To help keep the MTD log splitter in proper running order, MTD recommends the following maintenance intervals
be used (adjustable to local conditions).
.
Beam and wedge
The beam and wedge should be cleaned and oiled every time the log splitter is used. To clean the beam and
wedge:
1.
Brush all dirt and debris out of the log dislodger.
2.
Brush all dirt and debris off of the beam and from under the wedge.
NOTE: Any debris trapped under the wedge can prevent the wedge from moving freely up and down the
beam. This can result in failure of the wedge and damage the beam.
3.
Put a small amount of engine oil on a shop rag or a paper towel.
4.
Wipe the beam down with the oiled rag so that there is a light coat of oil on the beam.
CHAPTER 8: MAINTENANCE
Maintenance Point
Clean beam and wedge
of debris
Oil the beam
Engine oil change
Hydraulic oil change
Hydraulic oil filter
Wheel bearings
* First oil change at 5 hours
www.mymowerparts.com
Interval
Every use
Every use
25 hours*
100 hours
50 hours
varies with distance and
speed towed
Maintenance
61
Hide quick links:
Advertisement
Table of Contents
