MTD 2010 Shop Manual page 60

For Parts Call 606-678-9623 or 606-561-4983
2010 Log Splitters
Metal fender
To remove/replace a metal fender:
1. Remove the wheel by following the procedures
described in the wheel assembly section of this
chapter.
2. Remove both of the screws that hold the fender to
the tank using a 1/2" wrench. See Figure 7.11.
3. Install the fender by following the previous steps in
reverse order.
NOTE: The left and the right fenders have the same
part number.
NOTE: There are a lot of bolt holes in the fender to
accommodate all the different models of log
splitters that MTD makes. To find the right
bolt holes to use:
• Align the center bolt hole with the spindle.
• Slide the fender up and down until two of the bolt holes line up with the two holes in the tank.
56
www.mymowerparts.com
Screws
Figure 7.11