Chapter 5: Cylinder; Cylinder Removal - MTD 2010 Shop Manual

For Parts Call 606-678-9623 or 606-561-4983

Cylinder removal

Figure 5.1
2"x4" and stools used as a saw horse
Figure 5.2

CHAPTER 5: CYLINDER

low pressure
return line
www.mymowerparts.com
To remove/replace the cylinder:
1. With the engine turned-off, relieve hydraulic pressure
from the system by moving the lever on the control
valve through it's full range of travel.
Hydraulic fluid under high pressure
can be dangerous. A high-pressure
hydraulic fluid leak or spray can pen-
etrate the skin. If this happens, seek immediate
medical attention to reduce the risk of blood poi-
soning leading to death or limb amputation.
2. Thoroughly clean all dirt and debris from around the
valve.
NOTE: Any dirt or debris that gets inside the valve can
destroy it.
3. Place a suitable container under the valve to catch
any fluid that will leak out as the hydraulic lines are
removed. See Figure 5.1.
4. Place a saw horse or something similar under the
rear of the cylinder to support it. See Figure 5.2.
5. Remove the control valve by following the proce-
dures described in Chapter 4: Control Valve.
NOTE: The high pressure hose should be removed from
the base of the cylinder.
CYLINDER
37