MTD 290-004-000 Owner's Manual
  1. Manuals
  2. Brands
  3. MTD Manuals
  4. Log Splitter
  5. 290-004-000
  6. Owner's manual

MTD 290-004-000 Owner's Manual

Taillight kit
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

Made
in
AMERICA
• ASSEMBLY • PARTS •
LOG SPLITTER
TAILLIGHT KIT
Model Number
290-004-000
824-00265
IMPORTANT:
Read Instructions Carefully
FORM NO. 770-8749M

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 290-004-000 and is the answer not in the manual?

Questions and answers

Related Manuals for MTD 290-004-000

Summary of Contents for MTD 290-004-000

  • Page 1 • ASSEMBLY • PARTS • LOG SPLITTER TAILLIGHT KIT Model Number 290-004-000 824-00265 IMPORTANT: Made Read Instructions Carefully AMERICA FORM NO. 770-8749M...

  • Page 2: Rules For Safe Operation

    10. Do not tow the log splitter faster than 45 MPH. Higher speeds * If a “Statement of Origin” is required in your state, telephone may damage log splitter. Excessive high speeds may cause the 1-800-800-7310 and request one from MTD/YardMan Customer log splitter to “fishtail” or otherwise become unstable. Assistance.

  • Page 3: Operation

    2. Wear proper head gear to keep hair away from moving parts. 4. Do not straddle the splitter when using it. A slip in any position could result in a serious injury. 3. Always wear safety shoes. A dropped log can seriously injure your foot.

  • Page 4: Eye Protection

    4. Do not change the engine governor settings or overspeed the 11. The hydraulic system of your log splitter requires careful engine. This increases the hazard of personal injury. The maxi- inspection, along with the mechanical parts. Be sure to replace mum engine speed is preset by the manufacturer and is within frayed, kinked, or otherwise damaged hydraulic components.
  • Page 5 ASSEMBLY INSTRUCTIONS HARDWARE PACK. Remove parts from the package 2. Mount the two taillight brackets to the log splitter and identify as listed below. fender braces using the (4) 5/16-24 x .75" long hex bolts, (4) 5/16" lock washers and (4) 5/16-18 QTY.
  • Page 6 8. Pull the yellow wire through the hole in the right 4. Assemble the taillights to the taillight brackets side of the beam, and crimp it to the red wire com- using the mounting screws, lock washers and nuts ing from the right taillight using the connector packed with the lights.
  • Page 7 Right Side Black Wire With Ring YELLOW Right Turn Signal/Stoplight Terminal BROWN Taillight Conduit GREEN Left Turn Signal/Stoplight Flat Male Connector WHITE Ground Connectors 3/8" Jam Black Wire Refer to figure 9 License With Ring for connector Plate Terminal wiring details Side FIGURE 7.
  • Page 8 For Replacement Parts, Contact: SERVICE DEPARTMENT • P.O. BOX 368022 • CLEVELAND, OHIO 44136-9722...

This manual is also suitable for:

824-00265

Table of Contents