Beam - MTD 2010 Shop Manual

For Parts Call 606-678-9623 or 606-561-4983
2010 Log Splitters

Beam

To remove/replace the beam:
1. With the engine turned-off, relieve hydraulic pressure from the system by moving the lever on the control valve
through it's full range of travel.
NOTE: If the shop has equipment that can safely lift the cylinder without straining the hydraulic lines, this job
can be done without disconnecting the hoses.
Hydraulic fluid under high pressure can be dangerous. A high-pressure hydraulic fluid leak or
spray can penetrate the skin. If this happens, seek immediate medical attention to reduce the
risk of blood poisoning, which can lead to death or limb amputation.
2. Thoroughly clean all dirt and debris from around the
valve.
NOTE: Any dirt or debris that gets inside the valve
can destroy it.
3. Place a suitable container under the valve to catch
any fluid that will leak out as the hydraulic lines are
removed. See Figure 6.3.
4. Loosen the hose clamp on the low pressure return
line using a 5/16" wrench.
5. Disconnect the low pressure return line.
6. Disconnect the high pressure hose from the pump.
7. Disconnect the high pressure supply hose from the
valve using a 15/16" wrench. See Figure 6.4.
48
www.mymowerparts.com
Figure 6.3
Control valve
Figure 6.4
low pressure
return line
high pressure
supply hose