Restricting Wireless Access By Mac Address - NETGEAR ProSafe WG102 Reference Manual

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102

Restricting Wireless Access by MAC Address

To restrict access based on MAC addresses, follow these steps:
1. Connect to the WG102.
Log in at the default LAN address of http://192.168.0.229 with the user name of admin and
default password of password, or using the LAN address and password that you set up.
Note: When configuring the WG102 from a wireless computer whose MAC address
is not in the access control list, if you select Turn Access Control On, you will
lose your wireless connection when you click Apply. You must then access the
wireless access point from a wired computer or from a wireless computer
which is on the access control list to make any further changes.
2. From the Security menu, click the Access Control link to display the Access Control List
menu shown below.
Figure 3-12
3. Select the Turn Access Control On check box.
v1.0, November 2005
3-23