NETGEAR ProSafe WG102 Reference Manual page 35

802.11g wireless access point

Hide thumbs Also See for ProSafe WG102:

Table of Contents

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102

•

IP Address. The default IP address is 192.168.0.229. If you want to change it, enter an unused

IP address from the address range used on your LAN (factory default: 192.168.0.229); or

enable DHCP.

•

IP Subnet Mask. Enter the subnet mask value used on your LAN (factory default:

255.255.255.0).

•

Default Gateway. Enter the IP address of the Gateway for your LAN. For more complex

networks, enter the address of the router for the network segment to which the wireless access

point is connected (factory default: 0.0.0.0).

•

DNS Server. Enter the IP address of the DNS (Domain Name Server) you wish to use (factory

default: 0.0.0.0.

•

Enable 802.1Q VLAN. Check the box Enable 802.1Q VLAN to enable the WG102 to process

VLAN membership information.

•

Time Zone. Select the Time Zone to match your location. If your location uses daylight

saving, check the box Adjust for Daylight Saving Time.

The Current Time, as used on the wireless access point, is displayed.

Note: You must have an Internet connection to get the current time.

v1.0, November 2005

3-11

Table of Contents