Winterhalter UC-S Repair Manual page 27

Procedures
Required material:
Tool:
The following steps refer to the detergent dosing device Fluidos DT.
However, they also apply for the exchange of the rinse aid dosing
device Fluidos DB.
Observe the safety notes on page 7
Remove the front panel
Pull the suction pipes out of the chemical containers
Put the suction pipes into a measuring cup with water
Activate the dosing device in the actor programme in order to
rinse it with water
Remove the right stiffener wall
Pull off suction and pressure hose at the dosing device
Remove the left stiffener wall
Unscrew the dosing device
Fix new dosing device at the stiffener wall
Fluidos DT: Adjust the setting screw to MAX
Fluidos DB: Adjust the setting screw to MIN
Fix the suction and pressure hose at the pump head
Install both stiffener walls
Put the suction pipes into the chemical containers
Install the front panel
Carry out a function test
Ventilate the dosing devices
Carry out a safety test according to VDE 0701
Kit Fluidos DT (detergent)
Item no. 31 02 597
Kit Fluidos DB (rinse aid)
Item no. 31 02 598
no special tool required
25