Notices; Voltage Supply Switch Settings - IBM 2193 Maintenance Service Manual

Notices

References in this publication to IBM products, programs, or
services do not imply that IBM intends to make these available
in all countries in which IBM operates. Any reference to an IBM
product, program, or service is not intended to state or imply
that only IBM's product, program, or service may be used. Any
functionally equivalent product, program, or service that does
not infringe any of IBM's intellectual property rights, or other
legally protectable rights, may be used instead of the IBM
product, program, or service. References in this publication to
IBM products, programs, or services are purely hardware-
related and do not cover circumstances of software problems.
Evaluation and verification of operation in conjunction with other
products, program, or services, except those expressly
designated by IBM are the user's responsibility.
IBM may have patents or pending patent applications covering
subject matter in this document. The featuring of these patents,
pending or otherwise, in this document does not give you any
license to these patents. You can send license inquires, in
writing, to the IBM Director of Commercial Relations, IBM
Corporation, Purchase, NY10577.

Voltage Supply Switch Settings

Your IBM Personal Computer might have voltage switches,
which must be set correctly for your voltage supply. If your
monitor or system unit has a voltage switch, complete these
steps to make sure each switch is set correctly:
1. Determine the correct voltage switch setting for your area:
Voltage Supply Range
100-127 V
200-240 V
2. Locate the voltage switch on the back of your monitor or
system unit. If the setting shown on the switch is:
Correct: start setting up your IBM personal computer.
Incorrect: change the voltage switch setting.
4
Voltage Switch Setting
110 V
220 V