IBM 2193 Maintenance Service Manual page 77

Table 2-3 Error Symptoms List
Error Symptoms Action/FRU
NOTE: To diagnose a problem, first find the error symptom
in the left column. If directed to a check procedure, replace the
FRU indicated in the check procedure. If no check procedure
is indicated, the first Action/FRU listed in right column is the
most likely cause.
Processor
NOTE: Normally, the processor fan should be operative,
and the processor clock setting should be exactly set to match
its speed requirement before diagnosing any processor
problems.
Processor fan does Make sure that the system is not in
not run but power power saving mode. See "Power
supply fan runs. Management Setup" on page 55.
With the system power on, measure
the voltage of processor fan connector
FN. (See "Power Supply Cable
Connector Specifications" on page 157
and refer to the connectors and
functions illustrated in chapter 5.) Its
reading should be +12Vdc.
Processor fan.
System board.
Processor test failed. Processor.
System board.
System Board
NOTE: Ensure that the memory modules are installed
properly and the contact lead is clean before diagnosing any
system problems.
Memory test failed. "Memory" on page 92
System board
Incorrect memory size Insert the memory modules in the
shown or repeated DIMM sockets properly, and then
during POST. reboot the system.
Memory module. See the "Step 005"
of "Memory" on page 92 to replace
memory module.
System board.
75