IBM 2193 Maintenance Service Manual page 87

IDE Primary Channel Master and Slave Drives in BIOS
Setup should be connected to the system board primary
IDE connector. (Please refer to the connectors and
functions illustrated in chapter 5.)
IDE Secondary Channel Master and Slave Drives in BIOS
Setup should be connected to the system board secondary
IDE connector. (Please refer to the connectors and
functions illustrated in chapter 5.)
NOTE: The CD-ROM drive that comes with system unit
should be configured as IDE Secondary Channel
Master device.
Check the hard disk and CD-ROM drives jumper settings.
See "3.5-In. Hard Disk Drive Jumper Locations" on page
161 and "CD-ROM Drive" on page 91.
Check the voltages of all disk drive power connectors.
See "Power Supply Cable Connector Specifications" on
page 157.
Correct the parameter settings under Disk Drives in the
BIOS Setup. See "IDE Drives Setup" on page 54.
In the BIOS Setup, check that the correct drive size is set
for the flagged drive shown in the Installed Devices list.
Load default settings.
If the problem remains, check the continuity on the drive
and the cable and replace it if necessary. If that does not
fix the problem, replace the system board.
End.
005 –
Select Diagnostics from the PC-Doctor diagnostics
program main menu. Select and execute Floppy Disk
Test if you want to test the diskette drive. Select and
execute Hard Disk Test if you want to test the hard disk
drive.
Select Interactive Tests from the PC-Doctor diagnostics
program main menu, then select and execute CD-
ROM/DVD Test if you want to test the CD-ROM drive.
If the diagnostics program did not detect a failure, but the
system still displays a failure:
If an error or other symptom appears, go to "Index of
Symptoms, Messages, Error Codes, or Beeps" on page 69.
If no error can be detected or the symptom is intermittent,
go to "Undetermined Problems" on page 101.
End.
85