IBM 2193 Maintenance Service Manual page 75

Micro tower and desktop models
Hide thumbs Also See for 2193:
Table of Contents

Advertisement

Table 2-1
BIOS Error Codes, Messages, and Beeps List
BIOS Error Codes,
Action/FRU
Messages, beeps
NOTE:
To diagnose a problem, first find the BIOS error
messages, codes, or beeps in left column. If directed to a
check procedure, replace the FRU indicated in the check
procedure. If no check procedure is indicated, the first
Action/FRU listed in right column is the most likely cause.
PRESS F1 TO
When BIOS detects a Non-maskable
DISABLE NMI, F2 TO
Interrupt condition during boot, this will
REBOOT
allow you to disable the NMI and
continue to boot, or you can reboot the
system with the NMI enabled.
RAM PARITY
Indicates a parity error in Random
ERROR – CHECKING
Access Memory.
FOR SEGMENT ...
Memory parity Error
Indicates a memory parity error at a
at ...
specific location. You can use this
location along with the memory map
for your system to find and replace the
bad memory chips.
Memory Verify Error
Indicates an error verifying a value
at ...
already written to memory. Use the
location along with your system's
memory map to locate the bad chip.
OFFENDING
This message is used in conjunction
ADDRESS NOT
with the I/O CHANNEL CHECK and
FOUND
RAM PARITY ERROR messages
when the segment that has caused the
problem cannot be isolated.
ERROR
Hard drive cannot be initialized. Be
ENCOUNTERED
sure the adapter is installed correctly
INITIALIZING HARD
and all cables are correctly and firmly
DRIVE
attached. Also be sure the correct
hard drive type is selected in Setup.
ERROR INITIALIZING
Cannot initialize controller. Make sure
HARD DISK
the cord is correctly and firmly
CONTROLLER
installed in the bus. Be sure the
correct hard drive type is selected in
Setup. Also check to see if any
jumper needs to be set correctly on
the hard drive.
FLOPPY DISK
Cannot find or initialize the floppy drive
CNTRLR ERROR OR
controller. Make sure the controller is
NO CNTRLR
installed correctly and firmly. If there
PRESENT
are no floppy drives installed, be sure
the Diskette Drive selection in Setup is
set to NONE.
73

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

634521962194219763441

Table of Contents