Factory-Installed Storage Devices - IBM 2193 Maintenance Service Manual

Factory-Installed Storage Devices

Use this check procedure to test any factory-installed drives.
ATTENTION: The customer may have customized settings in
the Setup Utility (other than default settings) on the
computer you are servicing. Running the Setup Utility
might alter those settings. Take note of the current
settings and verify that the customer settings are in
place when service is complete.
NOTE: If you cannot access the hard disk drive or load a
diskette from Drive A or load a CD from the CD-ROM
drive, make sure that the BIOS Setup Utility has the
startup sequence set with diskette, CD-ROM, and
hard disk drives.
001 - START
Insert the diagnostics diskette into the diskette drive.
Power-off then power-on the system unit.
002 - DO ANY POST MESSAGES, ERROR CODES, BEEPS,
OR SYMPTOMS OCCUR? (YES, READ AHEAD. NO,
GO TO STEP 003)
Go to "Index of Symptoms, Messages, Error Codes, or
Beeps" on page 69.
End.
003 -
Select Utility from the menu.
Select and execute Tech Support Form from the menu to
generate a system configuration report.
Compare the system configuration list with the actual
devices installed in system.
NOTE: If necessary, remove the cover and visually
compare the devices installed in the system unit
to those shown in the Tech Support Form.
004 - IF THE NUMBER OF DISKETTE, HARD DISK, OR
CD-ROM DRIVE IS NOT CORRECT, READ AHEAD;
OR GO TO STEP 005.
Check the cable installation of all disk drives.
Diskette drive should be connected to the system board
Floppy connector. (Please refer to the connectors and
functions illustrated in chapter 5.)
84