IBM 2193 Maintenance Service Manual page 67

Make sure that the monitor refresh rate is correct.
Note any symptoms, messages, error codes, or beeps.
Make sure that there are no diskettes or CDs in the drives.
002 - DOES AN IBM LOGO SCREEN APPEAR? (YES,
READ AHEAD. NO, GO TO STEP 004.)
Insert the diagnostics diskette in the diskette drive.
003 - DOES SYSTEM LOAD THE DIAGNOSTICS
PROGRAM FROM THE DISKETTE DRIVE? (YES,
READ AHEAD. NO, GO TO STEP 004.)
Follow the instructions on the screen and select Utility
from the diagnostics program menu.
Select Tech Support Form from the menu, press F5 to
execute, then generate a system configuration report.
Compare the system configuration list with the actual
devices installed in system.
NOTE: If necessary, remove the machine cover and
visually compare the devices installed in system
to those shown in the system configuration report.
Go to step 006.
004 - DO ANY MESSAGES, ERROR CODES, OR
SYMPTOMS APPEAR? (YES, READ AHEAD. NO,
GO TO STEP 005)
Go to "Index of Symptoms, Messages, Error Codes, or
Beeps" on page 69.
End.
65