GTX/GTX LTR/LTS 2000 Portable Radios Service Manual
Figure 1-12. Align Pins
5.
Press down on front shield until chassis, main
board, and front shield are seated tightly
together.
6.
Hook locking clips Þrst to the chassis tab, then
push clips over on shield with thumb until
clips lock into front shield holes (Figure 1-13).
Figure 1-13.
Reinsert Locking Clips
7.
Replace chassis gasket (Figure 1-14).
June 1999
Figure 1-14. Replace Gasket
8.
Place the chassis assembly and front housing
assembly on a ßat surface with the top face of
housing in a reverse and opposite direction
(Figure 1-15).
Figure 1-15. Place Chassis Opposite of
Radio Reassembly
1.
Insert the ßexible circuit tail from chassis to
ZIF connector on front housing board. Lock
the tail in the ZIF connector by pressing down
the latch.
Flexible circuit tail must be fully inserted
to prevent short circuiting.
68P02945C75-A
Radio Disassembly/Assembly
Radio Reassembly
Front Housing
NOTE
1-5