Front Housing Board Removal; Radio Reassembly; Front Housing Reassembly - Motorola GTX 2000 Service Manual

GTX/GTX LTR/LTS 2000 Portable Radios Service Manual
Chassis
Gasket
Main board
Shield
Figure 1-6. Separate Main Board From Chassis
6. Separate the ßexible circuit tail by undoing the
ZIF connector latch (Figure 1-7).
Figure 1-7. Separate Flexible Circuit Tail

Front Housing Board Removal

1. Place the front housing assembly with the
front facing down on a padded ßat surface.
This is to avoid the lens from being scratched.
2. Remove the front housing shield using
tweezers or sharp end screwdriver by undoing
the four side catches (Figure 1-8).
June 1999
Locking clips

Radio Reassembly

Front Housing Reassembly

68P02945C75-A
Figure 1-8. Remove Front Housing Shield
3. Separate the front housing board from the
front housing.
1. Place the front housing on a cushioned ßat
surface with the front facing down.
2. Place the keypad into the front housing
(Figure 1-9).
3. Place the board on the keypad in the housing
(Figure 1-9).
Figure 1-9. Place Keypad Into Front Housing
Radio Disassembly/Assembly
Radio Reassembly
1-3