Front Housing Reassembly Ñ Basic Model; Chassis Reassembly - Motorola GTX 2000 Service Manual

Radio Disassembly/Assembly
Radio Reassembly
4. Fold the LCD ßexible circuit (Figure 1-11).
Make sure the LCD ßexible circuit is outside.
5. Place the front housing shield into the front
housing using the four slots on the front
housing wall as the guide (Figure 1-10).
Figure 1-10. Place Front Housing Shield
Into Front Housing
6. Press down the shield at the four tabs until
tabs lock into the front housing catches.
7. Slide in the lightpipe (Figure 1-11).
LCD flexible
circuit
Figure 1-11. Slide In The Lightpipe
Front Housing Reassembly — Basic Model
1. Place the front housing on a cushioned ßat
surface with the front facing down.
2. Place the board in the housing (see the
following Þgure).
1-4
GTX/GTX LTR/LTS 2000 Portable Radios Service Manual
3. Place the front housing shield into the front
housing using the four slots on the front
housing wall as the guide (see the following
Þgure).
4. Press down the shield at the four tabs until
tabs lock into the front housing catches.

Chassis Reassembly

1. Place chassis on a ßat surface with the battery
rails downward.
2. Insert the ßexible circuit tail end (marked ÒRFÓ
into the ZIF connector on the RF board and
lock the connector by engaging the latch
(Figure 1-12).
3. Insert main board into chassis using alignment
pins as a guide (Figure 1-12).
4. Place front shield on main board using tabs as
a guide (Figure 1-12).
68P02945C75-A June 1999