Motorola GTX 2000 Service Manual page 29

Radio Disassembly/Assembly
Radio Reassembly
NOTE
The gasket helps keep the radio free from
unwanted dirt, dust, and water. We rec-
ommend using a new lubricated gasket
(part no. 3280545C01) when reassem-
bling the radio. Using an old gasket
could impair the overall seal quality of
the radio.
2. Insert assembled chassis, main board, and
front shield
approximately a 45-degree angle (Figure 1-16).
Exercise caution while inserting the volume
and frequency controls through the housing
top.
IMPORTANT
The main board must be inserted into
chassis (Step 3) before you can secure
chassis into radio housing.
3. Connect microphone/speaker ribbon cable.
4. While pressing chassis toward the housing
top, press the bottom end down into the
housing until the bottom housing wall snaps
over the chassis retaining studs.
1-6
into radio housing
GTX/GTX LTR/LTS 2000 Portable Radios Service Manual
at
Make certain that the
flexible circuit is completely
inside the housing.
Figure 1-16.
The chassis should snap Þrmly into place
and the ßexible circuit should be placed
nicely inside the radio.
5. Replace the knobs, antenna and battery.
68P02945C75-A
Insert Chassis into Housing
NOTE
June 1999